Tel: 512-552-1661
Send a message

* Washing Machine Water Valve* Motor coupler for a Kenmore , Whirlpool, Roper Washing Machine* Front Load Washer Water Pump * Lid Switch for Kenmore or Whirlpool Washer

 

Washing Machine Water Valve

Displayed above is a picture of a washing machine water valve. If your washer is getting little water or no water at all, then there is a high possibility that your water valve is bad. If your washer is getting water when your washing machine is in off mode, then your water valve is bad. ???Get a volt meter and measure resistance across both wire terminals, there should be resistance, if not change it.

 

Motor coupler for a Kenmore , Whirlpool, Roper Washing Machine

The picture above shows a motor coupler for a Kenmore , Whirlpool, Roper and other washing machines. If your washer machine is making a noise or does not spin when in the spin cycle, then the motor coupler is bad and needs replacement.

 

Lid switch for for a Kenmore or a Whirlpool washing machine

If you have a Kenmore washer or a Whirlpool washer and it agitates but doesn’t spin at all, then the problem might be a bad lid switch shown above.

 

Front Load Washer Water Pump

Here is a picture of a front load washer water pump. Please read the unit’s operating manual located on the right side, this will provide you with Error codes and important information for the unit. It provides you information on how to put your unit on a diagnostic mode which can show you if the front load washer is running good or not or which component is failing.

 

We provide repair service 24/7. Please call us any time at 512-552-1661.